![]() ![]() Switch USB debugging back on in your phone settings, and reconnect the phone back - you'll see windows load another set of drivers for your phone. Once reinstalled, disconnect the phone off USB.and wait for the drivers to get reinstalled. Connect the phone to your PC with USB cable and let windows load your drivers.(minimum 1-2 minutes - recommended 5mins to 30mins) its found in Settings | Display. (Optional) Set your phone's screen timeout to a lengthy time.Most importantly, it must set as PDA when you exit. In that window's USB section, if it's default to PDA, tap MODEM, then back to PDA, (if it is MODEM in the beginning, change it to PDA) then press the back key to exit. Once rebooted, go to your phone's dialer, type *#7284# - A configuration window will appear.Reboot your phone (or turn off and then on your phone again).Follow instructions and wait for it to finish the troubleshooting procedure. open KIES, go to Tools | Troubleshoot connection error. Reboot your PC and Reinstall KIES after that. Here are steps : ( for Windows specific instructions): Samsung mobile MTP Device cannot be installed ![]() I have followed the Exact steps from Link : No frozing, no error.Įven though I have tried to wiggle the microusb plug in from every possible angle, it does not seem to have any effect. I forced the download mode once again and plugged the USB cable in. Then I rebooted the phone and came back to the issue later. One of the USB devices attached to this computer has malfunctioned ". On the sixth time, however, Windows found new hardware and started installing drivers but soon after that a balloon popped up saying "USB Device Not Recognized. ![]() I could reproduce this behaviour for 5 times. As soon as I did that, everything started moving again on the screen. ![]() I tried pressing every conceiveable keyboard combination from Enter to Ctrl+Alt+Del and then disconnected the USB cable. The PC froze at once (even the mouse cursor did not move). Then I used USB jig which I purchased from eBay to force the phone into download mode and tried to connect it with a PC once again. The update went fine but after the phone rebooted and I could confirm the firmware version from About, I still could not connect. I did not breathe on the phone and carefully clicked mouse to accept in hope that if this was a software error, new update would fix it. Then I tried to reinsert microusb plug into phone under an angle and witnessed a successful connection. I reimaged the PC and redid the z4root+Rom Manager+Recovery Mode wipe thing but nothing. Just to be sure, I pulled the cable from computer, waited for 2 secs and then reconnected but, alas, nothing happenend again. There I deleted-erased-formated everything I could and when I got back to normal mode and tried connecting again, Windows found new hardware and Kies recognized the phone. I tried an app z4root which rooted the phone without the need of usb cable, then I could use Rom Manager to force the phone into Recovery Mode (remember my phone had the 3-button combo disabled). Is there anything else I could try before sending it to the long journey of Warrantyland? One of the USB devices attached to this computer has malfunctioned." error on Windows (XP). Then I saw the "USB Device Not Recognized. Entering download mode with mUSB jig (my phone has download and recovery modes disabled otherwise) and reconnecting mUSB cable. Trying reimaging PC to a known good state (where I previously would have found new hardware) Earlier I got to see Connect to Kies or something like that. I discovered today that I cannot connect my PC with Samsung GT-I9000 any more: when I plug in the microUSB cable, nothing happens other than that the phone starts to charge. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |